Silicone rubber for mold making (condensation series)

Silicone rubber for mold making

Features of Silicone rubber for mold making

Silicone rubber for mold making is mainly used for toy gifts and craftwork gifts with the advantages of good tensile strength, high tear strength, high temperature resistance, high duplication times and repeated use, etc. It is suitable for small products or fine and precision products which is difficult to demould. This silicone rubber is one of the products with the highest use level in the production of craftwork gifts and the shrinkage is up to 2.

Applications of Silicone rubber for mold making:

Poly technique, lightings, candles, and  molds in multiple pieces for large products. Very suitable for concrete, resin, plaster, polyurethane, polyester, candle, PU products.

Standard Datasheet of Silicone rubber for mold making:

General Description of Silicone rubber for mold making:

Silicone rubber for mold making and silicone rubber are general called two-component room temperature vulcanization silicone rubber with excellent fluidity and good operational performance. Add curing agent of 2%-3% at the room temperature, the silicone rubber is still operational within 30 minutes,and in 2-3 hours, an elastic silicon mold will be obtained with resistance to deformation, high-temperature, acid and alkali and expansion. The silicone rubber is mainly applicable to mold duplication of poly crafts, resin craftworks, lightings, candles, etc. and fabrication of precision molds.

Operation Instruction for Silicone rubber for mold making:

Silicone rubber for mold making is white or red flowing liquid with general hardness of 22-50A°after curing . If the customer wants to make large products and large size molds, the mold should be made of silicone rubber with high hardness. On the contrary, if  the mold with fine and precision patterns , it should be made of silicon with low hardness. The amount of the curing agent depends on the actual requirements of the customer. If molds requiring fast drying and demould, more curing aent is needed; contrarily, if molds requiring slower drying and demould, less curing agent is needed.

(Note: our company does not recommend you to add silicone oil. If a special soft silicon mold or fine detailed and complex patterns products are required, 5%-10% silicone oil can be added to soften the mold for easy demould.)

The proportions and reactions of the curing agent and the silicon are listed as follows:

1. Adding curing agent 1%, the silicone can still be operated within 2.5 hours and can be demoulded after 6-8 hours.

2. Adding curing agent 2%, the silicone can still be operated within 50 minutes to 1 hour and can be demoulded after 2-3 hours.

3. Adding curing agent 3%, the silicone can still be operated within 28 - 30 minutes and can be demoulded after 1.5-2 hours.

4. Adding curing agent 4%, the silicone can still be operated within 10 - 15 minutes and can be demoulded after 1 -1.5 hours.

Any questions for silicone rubber for mold making, pls feel free to contact Taylor:

Tel:0086-755-89212380

Mob:0086-18938867522

Skype: taylordl828

Facebook: hyw(at)szrl(dot)net