Search This Supplers Products:Mold making Silicone rubberSilicone RubberLiquid Silicone rubberMolding Silicone RubberSilicone OilPad Silicone rubber
US $9.35200 - 40,000 kilogram
US $6.6840,001 - 999,999 kilogram
Paramtents
Shaping Mode Silicone Mould
Product Material Rubber
Product Vehicle Mould
Feature liquid silicone rubber
Type condensation silicone rubber
Mixing ratio 100:5
Pot life 30-40 minutes
Curing time 3-5 hours
Curing agent 4% for free charged
Certificate ROHS,SGS,ISO9001:2000,FDA
Packging & Delivery
Min Order200 kilogram
Briefing
Detailed
Applications of RTV molding silicone rubber for concrete baluster moulds making
RTV molding silicone rubber is mainly applied for making various molds,such as reproduction of
poly resin, epoxy, polyurethane-polymer, plaster, gypsum, soaps, candle & lighting, architecture,
decorative arts and crafts, plastic toy, gift and stationery, big statue, cultural relic product, etc.
Description of RTV molding silicone rubber for concrete baluster moulds making
The manual mold silicon rubber features with the resistance to deformation, good tensile strength as well as low shrinkage, and time of reproduction determined on the basis of customers.
Operation of RTV molding silicone rubber for concrete baluster moulds making
1. Stir part A and part B with right mixing ratio (100:5) evenly. And get the mixture for vacuum-pumping. (If there is no vacuum machine, just mix less catalyst)
2. Clean your products and brush a layer of release agent (detergent or soap water) on your product.
3. Pour the mixture with correct mixing ratio into the model frame.
After about 3-5 hours, when the silicone get cured, take out the original mold, and there is th finished silicone mould.
FAQ of RTV molding silicone rubber
What should we do when the air bubbles appeared in the process of mold making ?
To handle this situation depends on different cases. Under the condition of an available vacuum pumping machine, mix the silicone rubber and curing agent evenly and then take it to vacuum chamber to deair. If without a vacuum pumping machine, reduce the amount of the curing agent properly. For example, change the mixing ratio of the silicone rubber and the curing agent from former 4% to 1%-2%. In this way, the pre-crosslinking time of silicone rubber will slow down, so, the air in the mold will be eliminated gradually to reduce the air bubbles.
Any questions of RTV molding silicone rubber for concrete baluster moulds making, please feel free to contact Ms Vicky:
TEL: 0086-755-89212369
FAX: 0086-755-89948030
MOBILE: 0086-18938867569
Skype: vickylyr
网络文化经营许可证:浙网文[2013]0268-027号|增值电信业务经营许可证:浙B2-20080224-1 2007-2024 Tradevv.com. All rights reserved.