Sell HONGYE Platium cured silicone rubber for large plaster mould

     Sell HONGYE Platium cured silicone rubber

           for large plaster mould

For the platinum silicone rubber ,have many good features as below:

odourless and non toxic.

Long mould life

virtually no shrinkage

high tear resistance

high dimensional stability over time

non-deformability and excellent reproduction of fine detail.

Is very suitable to make the complicated large mould in detail

Some of the materials you can cast into a silicone mold are:

Urethane Plastic

Urethane Rubber (sold in store)

Epoxy

Polyester

Fiberglass Resign

Plaster

Soap

Wax

Low melt metals (up to 400 degrees Max)

HydroCal White

UltraCal 30

Hydrocal, Hydrostone

Cement, Concrete

Using Instructions:

1. Applicable to the injection molding process
2. Mixing component A with B evenly according its mix ratio, it is ready for use after degassing , it cures by heating up the temperature when pouring into the mold.
3. The curing time is subject to the temperature, short time will be required under high temperature, long time will be required while the product with large thickness.

Any further information required ,pls feel free to contact Miss Samina and call the mobile of 0086-18938867533 or the phone 0086-755-89212365. Welcome to visit www(dot)szrl(dot)netanytime .