Search This Supplers Products:Mold making Silicone rubberSilicone RubberLiquid Silicone rubberMolding Silicone RubberSilicone OilPad Silicone rubber
US $13.30200 - 40,000 kilogram
US $6.9840,001 - 999,999 kilogram
Paramtents
Color high translucent
high translucent 1:1
Certification SGS,MSDS,RoHS
Material 100% silicone
Classification Chemical Auxiliary Agent
Appearance Fluid
Appliacation molding
Packging & Delivery
Min Order200 kilogram
Briefing
Detailed
1. liquid silicone rubber for shoe insoles casting making Introduction:
HY- E620# addition molding silicone is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making masks, arms, legs, and other FDA molds application.
2. liquid silicone rubber for shoe insoles casting making Application:
HY- E620# addition molding silicone could be mainly used for making silicone insoles, concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.
3.Technique Data of liquid silicone rubber for shoe insoles casting making :
Model | HY-E620# |
Appearance | Translucent |
Mixing Ratio | 1:1 |
Operating time (Mins 25°C) | 10-15 |
Curing time (Mins 25°C) | 30-50 |
Hardness (A°) | 18-20 |
Density ( g/cm 3 ) | 1.0 |
Viscosity (CS) | 7000±3000 |
Tensile-strength( kgf /cm2 ) | >13 |
Tear-strength (kgf /cm2 ) | > 3 |
Elongation-break(%) | >450 |
Retractility(%) | ≤0.1 |
4.OPERRATING INSTRUCTION of liquid silicone rubber for shoe insoles casting making :
1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)
2. Enclose the product (the original model) with four plastic plates or wooden plates.
3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.
4. Pour the mixture with correct mixing ratio into the model frame.
After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .
SHELF LIFE: Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.
Any questions of liquid silicone rubber for shoe insoles casting making , please feel free to
contact Aaron:
TEL: 086-755-89948006
FAX: 086-755-89948030
MOBILE:086-13622300503
网络文化经营许可证:浙网文[2013]0268-027号|增值电信业务经营许可证:浙B2-20080224-1 2007-2024 Tradevv.com. All rights reserved.