Silicone material for making insole

FOB Price

US $12.35200 - 40,000 kilogram

US $7.9840,001 - 999,999 kilogram

group name: Liquid silicone rubber for insoles

Min Order: 200 kilogram

brand name: Hong Ye silicone rubber

model: HY-E620,HY-E625,Q-620,Q625

Nearest port for product export: Shenzhen, Guangzhou, Xiamen, Shanghai

Delivery clauses under the trade mode: FOB, CFR, CIF

Acceptable payment methods: T/T, L/C, Westem Union

Export mode: Export through agents

update time: Fri, 08 Nov 2013 21:26:58 GMT

contact supplier

Paramtents

Color high translucent
high translucent 1:1
Certification SGS,MSDS,RoHS
Material 100% silicone
Classification Chemical Auxiliary Agent
Appearance Fluid
Appliacation molding

Packging & Delivery

Min Order200 kilogram

Briefing

1. Good characteristics of easy-operation
2. Ligh viscosity and good flowability
3. Low shrinkage
4. Favorable tension

Detailed

1. Silicone material for making insole mold Introduction:

HY- E620# addition molding silicone is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making masks, arms, legs, and other FDA molds application.

2. Silicone material for making insole mold Application:

HY- E620# addition molding silicone could be mainly used for making silicone insoles, concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Silicone material for making insole

3.Technique Data of Silicone material for making insole mold :

Model	HY-E620#
Appearance	Translucent
Mixing Ratio	1:1
Operating time (Mins 25°C)	10-15
Curing time (Mins 25°C)	30-50
Hardness (A°)	18-20
Density ( g/cm 3 )	1.0
Viscosity (CS)	7000±3000
Tensile-strength( kgf /cm2 )	>13
Tear-strength (kgf /cm2 )	> 3
Elongation-break(%)	>450
Retractility(%)	≤0.1

Silicone material for making insole

4.OPERRATING INSTRUCTION of Silicone material for making insole mold :

1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

SHELF LIFE: Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

Need any help on silicone rubber, please feel free to contact Ms Kitty:

Tel:86-755-89948294

Mob:86-18938867593

E-mail: hysh(at)szrl(dot)net

Skype:kity-467707861

Silicone material for making insole